提花机厂家
免费服务热线

Free service

hotline

010-00000000
提花机厂家
热门搜索:
技术资讯
当前位置:首页 > 技术资讯

NS LM3409 PFET降压控制大功率LED驱动方案 消费电子 免费猫

发布时间:2020-02-17 13:38:34 阅读: 来源:提花机厂家

NS LM3409 PFET降压控制大功率LED驱动方案 - 消费电子 - 电子工程网

This evaluation board showcases the LM3409HV PFET controller for a buck current regulator. It is designed to drive 12 LEDs (VO = 42V) at a maximum average LED current (ILED = 1.5A) from a DC input voltage (VIN = 48V). The switching frequency (fSW = 400 kHz) is targeted for the nominal operating point, however fSW varies across the entire operating range.

The circuit can accept an input voltage of 6V-75V. However, if the input voltage drops below the regulated LED string voltage, the converter goes into dropout and VO = VIN ideally. The PCB is made using 4 layers of 2 oz. copper with FR4 dieletric. The evaluation board showcases all features of the LM3409HV including analog dimming using the IADJ pin and internal PWM dimming using the EN pin. High frequency external parallel FET shunt PWM dimming can also be evaluated.

The board has a header (J1) with a removable jumper, which is used to select the PWM dimming method. The evaluation board has a right angle connector (J2) which can mate with an external LED load board allowing for the LEDs to be mounted close to the driver. This reduces potential ringing when there is no output capacitor. Alternatively, the LED+ and LED- turrets can be used to connect the LED load.

This board can be easily modified to demonstrate other operating points as shown in the Alternate Designs section. The LM3409/09HV datasheet Design Procedure can be used to design for any set of specifications.

Since the board contains a buck regulator designed for 48V input, the efficiency is very high at input voltages near or less than 48V. The switching frequency increases as input voltage increases, yielding lower efficiency at higher input voltages.

Note that increasing the off-time resistor (R6) will increase the efficiency at high input voltage.

书旗小说全集免费阅读

乌海旗袍

白凤菊种植

红旗渠小故事